View Articles by Product or Module

There are no sub categories

Category » Print Sectionsrss button

There were 7 articles found in this category:

  1. questionMy Collar Plan has structure symbols in the map, which are not rotated correctly
    Occurrence When I print my sections and add a collar plan, the rotated map view in the collar plan window has not correctly rotated the structural symbols. Solution This is caused by MapInfo not rotating symbols, when an affine projection is applied to rotate the map. Everything else in the m ...
  2. questionHow do I create stacked drillhole cross sections?
    Solution There are no tools to automatically stack drilhole cross sections. However you can manually stack and align cross section in a layout window. To do this, use DRILLHOLES>Section Output>Print Sections, and select multiple sections you use to add in the layout. Then in the layout y ...
  3. questionWhen I add a Collar Plan to my scaled section output, it doens't fit on the page
    Occurrence If you are Printing sections (Add section to layout or scaled section output), and tick the option to Add Plan of Collars to Layout the section no longer fits on the page. Solution This has always been a limitation of the design, as it does not require you to create and define the ...
  4. questionI cannot change my Frame size
    Occurrence In Scaled Output or Print Sections, I cannot change the Frame Size! It is disabled and says "as selected". Solution When you start Scaled Output, if you have a polygon selected it will use this as the frame size. Close Scaled Output, and go to TABLE>Selection>Clear, and then ...
  5. questionError: “No Sections or Plans to Add to Layout Window”
    Occurrence A number of sections are open, but upon clicking the “Add Section to Layout” this error occurs. Solution Firstly, ensure the project is open by selecting Drillholes>Project Manager, and then click Open. Then simply close and re-open the sections use the Drillholes ...
  6. questionMy drillhole plans don't appear in the Add Section to Layout tool.
    Plan sections are not supported in the Add Section to Layout tool, only vertical sections can be plotted. Drillhole plans can be printed using the standard Scaled Output tool to generate a plot.
  7. questionHow do I customise the page frame size in Drillholes>Add Section to layout?
    Solution The frame sizes availble are determined by those available in the Discover Scaled Output tool. To create a custom frame size navigate to Discover>Scaled Output>Config and create a custom frame, which then can used in the Drillhole Module Add Section to Layout tool.